SAMALLOY PC 6060GF10-10

Physical Nominal Values (English) Test

Specific Gravity 1.28 g/cm³                    ASTM D 792

Melt Flow Rate (300 °C/1.2 kg.) 10 g/10 min        ASTM D 1238

Mechanical

Tensile Strength                                              62 MPa                                                      ASTM D 638

% Elongation @ Break 4%        ASTM D 638

Tensile Modulus 3800 MPa        ASTM D 638

Flexural Modulus 3700 MPa        ASTM D 790

Flexural Strength @ Yield 120 MPa        ASTM D 790

Impact

Notched Izod Impact (23 °C)                         56 J/m            ASTM D 256

Thermal

DTUL @ 1.8MPa 3.2mm un-annealed 120 °C        ASTM D 648

Mold Shrinkage

Linear Flow 0.3% - 0.6%        ASTM D 955

UL Rating V0 (1.5mm)        UL 94

           HB (0.4mm)        UL 94

RoHS Compliant Pass

The information provided above is based upon typical values. Typical values are intended only as guides. Each customer is responsible for determining whether products and information in this document are appropriate for the customer’s use.  Manufacturer assumes no obligation or liability for any advice furnished or for any results obtained with respect to this information.  NO GUARANTEES OR WARRANTIES ARE EXPRESSED OR IMPLIED.

The conditions listed above are only guidelines. You may want to adjust conditions to meet your requirements.  

Tips on resolving common surface issues:

1. Check the dryer mechanical functions and temperature settings as well as the time in the dryer.  

Shooting an air-shot from the barrel helps to indicate poor drying conditions.  If the air-shot

bubbles and foams, then poor drying is suspect.

2. Excessive heat via:  temperature settings too high; too fast of an inject speed; small/tight

gating or other shear induced heating, are common items to review.